Install guide
Cybertruck Projection Lights
Tesla's owner procedure for swapping the front door puddle lights for the Cybertruck logo projection lights.
Follow the manufacturer's instructions; this WedgeMods summary may be incomplete.
- Difficulty
- Easy
- Time
- The published instructions do not state a time.
- Product
- Tesla listing
From the instructions
Do not close the door while the light is being installed. Tesla says that can damage the window. The left and right lights go in the matching front doors, and the right side mirrors the left.
Tools
A small screwdriver or pry tool to lift the factory puddle light.
Steps
Step 1
Drop the window
Open the left front door and lower the window all the way. Pry the factory puddle light out of the bottom of the door panel.
Step 2
Unplug the old light
Press the locking tab and disconnect the connector. Do not pull the light far out while it is still plugged in.
Step 3
Plug in the projection light
Line up the raised ribs with the slot in the door. Connect the harness. Tesla says a correct connection turns the light on and shows the Cybertruck logo.
Step 4
Snap it in
Push the light up into the opening until it snaps in. Raise the window, close the door, and repeat on the right.
Follow the manufacturer's instructions; this WedgeMods summary may be incomplete.