Install guide
Ultra-Bright Lights for Cybertruck (Pick n Mix)
Abstract Ocean's written cabin-bulb swap for the ten interior light locations. The page also points at a video.
Follow the manufacturer's instructions; this WedgeMods summary may be incomplete.
- Difficulty
- Moderate
- Time
- The published instructions do not state a time.
- Product
- Abstract Ocean listing
From the instructions
These bulbs are Cybertruck-specific. Abstract Ocean says other Tesla bulbs will not work on the 16V side of the truck's lighting, and that puddle lights are not part of this guide. If a new bulb stays dark, let the truck sleep overnight so the soft fuses reset.
Tools
A trim tool or spudger. A flat screwdriver only if the tip is wrapped or the trim is taped. Snips if an under-seat bulb will not release. A non-metal trim tool for the center console panel.
Steps
Step 1
Plan the time
Ten locations in all. Five need no trim off: the four doors and the center of the rear passenger footwell. Allow about an hour to an hour and a half for all ten, or 30 to 45 minutes for those five. If the cabin lights time out, close the doors and open them again.
Step 2
Swap the door bulbs
Pry each door light out, depressing the clip on each side. Keep a short harness from falling back into the door. Press the connector clip, slide it off, fit it fully on the new bulb, and press the light in until it is flush. All four doors are the same.
Step 3
Swap the rear footwell center
Pry that hard-plastic light out, release the connector, fit the new bulb, and push the light home.
Step 4
Drop the dash trim
Both front footwell lights sit behind the long trim under the dash. Release it from one end, across the magnetic and Velcro center, to the clips at the far end. The fabric strap can stay bolted unless you need the extra room. The page counts three center magnets, a Velcro strip, and five clips.
Step 5
Swap the front footwell bulbs
Pry or push each footwell bulb out, move the connector, and clip the new light in. Refit from the driver side, reattach the strap if you removed it, and listen for the center magnets and five clips.
Step 6
Open the under-seat housings
Pop the two friction clips at the front of the housing and release the other end without stressing the cable. Fold the housing back, unplug the bulb, and cut the side pegs with snips only if it will not come out by hand. Plug in the new light, clip it in, and close the housing lip onto the metal frame. Repeat under the other front seat.
Step 7
Swap the console light
Release the front console panel with a non-metal tool, pry the tight light out, move the connector, and snap the new bulb in. Wake the lights and confirm it works. Refit the panel with the two top clips first, then the side clips. The page describes three clips down one side, two at the top, mirrored on the other side.
Follow the manufacturer's instructions; this WedgeMods summary may be incomplete.